Rocktron All Access - MIDI controller


gekauft am 15/03/2008
08/01/2009
The labels are off again and the assigns of the switches changed after a bit of try and error.
The new logic behind it :
'loop' switches the Intellifex in and out of the signal  path.
RV (reverb) is no effect I switch on and off in a performing situation, so switch 12 can eventually be used for further control of the Intellifex.
Die Etiketten sind wieder 'runter und die Belegung der Tasten hat nach einigem Überlegen und Probieren eine neue Logik :
'loop' schaltet effektiv den Rocktron Intellifex LTD in den Signalweg.
RV (reverb) ist in meinen Anwendungen ein Effekt, den ich nicht im laufenden Betrieb ein- oder ausschalte, so dass Taster 12 gegebenfalls zur erweiterten Steuerung des Intellifex dienen kann.
Les auto-collants sont repartis et les assignations des interrupteurs suit une nouvelle logique - après un temps certain de réflection et de tests effectués.
'loop' permet de mettre le Intellifex dans/hors de la chaîne de signal.
RV (reverb) n'est pas un effet que je manipule pendant un concert, donc l'interrupteur 12 peut éventuellement être utilisé pour un contrôle plus large du Intellifex.
All Access # ASSIGN Target Min Max Source Mode Act. Range Low Acti. Range Hi
6 1 EQ : on/off OFF ON MIDI CC#06 Normal 0 127
7 2 Preamp Channel A/B OFF ON MIDI CC#18 Normal 0 127
8 3 OD / DS : on/off OFF ON MIDI CC#08 Normal 0 127
9 4 FX1 : on/off OFF ON MIDI CC#09 Normal 0 127
10 5 FX2 : on/off OFF ON MIDI CC#10 Normal 0 127
11 6 loop : on/off OFF ON MIDI CC#11 Normal 0 127
12 7 RV : on/off (reverb) OFF ON MIDI CC#12 Normal 0 127
13 8 DD : on/off (delay) OFF ON MIDI CC#13 Normal 0 127
14 9 CE : on/off (chorus) OFF ON MIDI CC#14 Normal 0 127
15 10 Master BPM (TAP) OFF ON MIDI CC#15 Normal 0 127
Pedal #1 11 Wah : on/off OFF ON MIDI CC#17 Toggle 126 127
Pedal #1 12 Wah : Pdl Pos 0 100 MIDI CC#17 Normal 0 120
Pedal #2 /       MIDI CC#16      
first version of assigns - erste Version der Belegung - première version des assignations
In the beginning, I used the 'momentary'-mode for the 'Direct-Access' switches.
This mode is not best working with the GT-Pro. Now I use the 'latch'-mode.
On the GT-Pro, every effect is de-activated; the All-Access activates the effects when choosing the patch.
The BPM-switch (#15)  has to be in 'momentary'-mode.
Switch nr 7 of the All-Access is related to ControlChange #7 by standard. This one has obviously to be changed, because CC#7 controls the volume by standard.
We have switches going up to #15; the expression-pedals have #16 and #17; so switch #7 is allocated with ControlChange #18.
This gives the chart below :
Anfangs habe ich die 'Direct-Access'-Taster des All-Access im 'momentary'-Modus betrieben. Der ist allerdings für eine reibungslose Zusammenarbeit mit dem GT-Pro nicht geeignet. Am besten funktionniert der 'latch'-Modus. Am GT-Pro werden alle Effekte abeschaltet und der All-Access aktiviert bei Anwahl des jeweiligen Patches die abgespeicherten Effekte. Der BPM-Taster (Nr. 15) muss alledings im 'momentary-mode' betrieben werden.
Der Taster Nr 7 des All-Access hat standardmäßig den ControlChange #7 zugewiesen. Dieser muss natürlich geändert werden, denn CC#7 regelt die Lautstärke.
Die Taster gehen bis #15; die beiden Expression-Pedale haben standartmäßig #16 und #17; also wähle ich #18 für diesen Taster.
Folgende Tabelle hat sich heraus-kristallisiert :
Au début, j'ai utilisé le mode 'momentary' pour les switches du All-Access.
J'ai constaté bien vite que le mode 'latch' était mieux approprié pour un tyravail sans faille avec le GT-Pro.
Dans les patches du GT-Pro, tout les effets sont désactivés. Le All-Access les active lors du choix d'un patch.
Le switch 'BPM' par contre doit rester en mode 'momantary'.
Le switch n° 7 est attribué au ControlChange #7, ce qui doit être modifié, puisque le CC#7 contrôle par défaut le volume.
Les switches vont jusqu'au 15, les pédales contrôlent le #16 et #17, donc j'attribue le #18 au switch 7, ce qui donne le tableau suivant :
ASSIGN Target Min Max Source Mode Act. Range Low Acti. Range Hi
1 EQ : on/off OFF ON MIDI CC#06 Normal 0 127
2 FX1 : on/off OFF ON MIDI CC#18 Normal 0 127
3 CS : on/off OFF ON MIDI CC#08 Normal 0 127
4 OD / DS : on/off OFF ON MIDI CC#09 Normal 0 127
5 FX2 : on/off OFF ON MIDI CC#10 Normal 0 127
6 Preamp Channel A/B OFF ON MIDI CC#11 Normal 0 127
7 RV : on/off OFF ON MIDI CC#12 Normal 0 127
8 CE : on/off OFF ON MIDI CC#13 Normal 0 127
9 DD : on/off OFF ON MIDI CC#14 Normal 0 127
10 Master BPM (TAP) OFF ON MIDI CC#15 Normal 0 127
11 Wah : on/off OFF ON MIDI CC#17 Toggle 126 127
12 Wah : Pdl Pos 0 100 MIDI CC#17 Normal 0 120



Rocktron HEX - Expression Pedal
I use an Rocktron HEX that I own for some time as expression pedal.
To be able to 'program' point 11 and 12 from the above list, I had to do a little modification to it : by placing 2 screws under the rubber-blocks of the pedal, I limited th normal course of the pedal to a value of around 120 to 122. By pressing down the pedal with some more force - to surmount the resistance of the rubber-blocks - you can get values up to 127.
Als Expression-Pedal kommt ein Rocktron HEX zum Einsatz, das ich schon seit einiger Zeit besitze. Allerdings musste ich es leicht umbauen um für die Zuweisungen Nr. 11 und 12 funktionstüchtig zu sein : Unter die beiden Gummipuffer des Pedals habe ich zwei Schrauben eingesetzt, damit der Weg des Pedals kurz vor Erreichen des Maximalwertes gestoppt wird - ich habe die Schrauben auf den Wert 120 bis 122 geregelt. Beim Durchtreten des Pedals gegen den Widerstand der Gummipuffer wird dann der Wert 127 erreicht. Comme pédale d'expression, j'utilise un Rocktron HEX que je possède depuis un certain temps. J'ai dû procéder à une petite  modification pour qu'il soit possible de programmer les attributions n° 11 et n° 12 du tableau ci-dessus : en-dessous des deux pièces en caotchouc, j'ai positionné deux vis pour que la course de la pédale s'arrète aux valeurs 120 à 122. En appuyant plus fort sur la pédale, pour surmonter la résistances des pièces de caotchouc, on obtient la valeur 127

Ein zweites Pedal gekauft am 17/01/2009